|Project: Midi Organ|
|Initiator||Duality and Renze|
|Skills||Midi, Hardware, C/C++, avr. (musical skills not needed)|
|Summary||A Midi Organ for learning and controle, and fun.|
The idea is to take all the electronics out and put in our own, interface some microcontrollers to the buttons and sliders on the organ.
Several separate MIDI-devices will be made:
* The button panel on the left. * The buttons on the bottom of the top panel. * The piano keys. * The pedals. * The top panel with most of the sliders.
We'll put a PC inside of the organ plus an amplifier connected to the original speakers. The PC will run some software (e.g. LMMS) that can interface to MIDI-devices.
what is it?
The type of the organ is Eminent Solina f217.
It is a analog organ, lots of mixers and oscillators inside.
It is pretty old, but it has a lot of sliders and buttons, and it has 88 single-velocity keys split into two piano keyboards.
how are we going to build it
every panel will have a microcontroller inside, except for the piano-keys that will have a arduino mega because of the number of pins connected.
every panel will then send it's midi commands over uart, towards a single microcontroller, maybe the arduino mega. the usb interface chip on it (atmega16u) will be configured as a midi-usb device.
that way we can connect multiple panels to a single usb device.
the usb serial chip will be programmed with mocolufa software that does this for you. a header connection put's it back into usb-serial mode for uploading firmware.
the pc will be installed with arch, and lmms will be installed.
a amplifier will be connected to the pc and to the speakers.
The piano keyboard part works, finally.
What did we learn.
DONT use zeners in keyboards/diode matreces.